26 11 020 Replacing center mount gaiter

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove PROPELLER SHAFT .

NOTE: The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).

Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.

Fig 1: Identifying Gaiter, Groove, Front And Rear Propeller Shaft

G08470219

Courtesy of BMW OF NORTH AMERICA, INC.

Pull apart propeller shaft.

Fig 2: Pulling Propeller Shaft

G04748989

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

If necessary, insert new clamping ring (1) into front propeller shaft (2).

Fig 3: Identifying Propeller Shaft Clamping Ring

G04748990

Courtesy of BMW OF NORTH AMERICA, INC.

Release gaiter (1) with screwdriver from groove (2) and pull off over longitudinal splines.

Installation note:

Apply an even coating of grease to longitudinal splines on shaft.

Grease, refer to DRIVESHAFT -- OPERATING FLUIDS .

Observe markings and force front propeller shaft onto longitudinal splines (markings must be flush).

Push gaiter (1) during installation into groove (2) and make sure it is firmly fitted.

Fig 4: Identifying Propeller Shaft Gaiter And Groove

G04748991

Courtesy of BMW OF NORTH AMERICA, INC.