12 61 280 Removing and installing/replacing oil pressure sensor (N55)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Turn off ignition
Remove IGNITION COIL COVER

WARNING: Risk of burning!
Only perform this task on an engine that has cooled down.

Installation location:

Oil filter housing, front left.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Unlock plug (1) and remove.

Release oil pressure sensor (2).

Tightening torque 12 61 1AZ .

Fig 1: Identifying Oil Pressure Sensor And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Add final details to vehicle.
Check engine oil level. Top up engine oil if necessary.