12 14 512 Replacing pulse sensor on left exhaust camshaft (N63 B40/B44 O 1)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

(cylinder bank 5 to 8)

Necessary preliminary tasks:

Read out fault memory of the DME control unit, work through test plans if necessary.
Switch off ignition.
Remove left INTAKE FILTER HOUSING

Partially release wiring harness if necessary.

Unlock connector (1) and remove.

Release screw (2).

Tightening torque 13 62 3AZ .

Remove pulse generator (3).

Installation note:

Replace sealing ring and coat with lubricant.

Fig 1: Identifying Connector, Screw And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Assemble engine.
Delete fault memory.