12 31 020 Removing and installing or replacing alternator (N55)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Switch off ignition
Disconnect BATTERY EARTH LEAD and cover.
Remove front CHARGE-AIR DUCT .
Remove rear CHARGE-AIR DUCT .
Remove alternator DRIVE BELT .

NOTE: In order to remove the alternator, it is necessary to REMOVE the air conditioning compressor.
In so doing:

Do not draw off A/C system refrigerant.
Do not detach refrigerant lines from A/C compressor.
Do not remove air conditioning compressor; instead, release from bracket only and place to one side.

Release screws (1).

Tightening torque 12 31 1AZ .

Fig 1: Identifying Screw And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2).

Tightening torque 12 31 2AZ .

Release screw (3) and remove with holder (4).

Tightening torque 12 31 2AZ .

Fig 2: Identifying Protective Cap And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Remove protective cap (2) and release nut underneath.

Tightening torque 12 42 1AZ .

Remove positive battery cable (3).

Fig 3: Identifying Screws And Alternator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of improved clarity, illustrations and description show A/C compressor removed.

Release screws (1) a few turns until bracket (2) is loose. Do not remove bracket (2).

Tightening torque 12 31 3AZ .

Feed out alternator (3) and remove.

Assemble engine.