17 21 010 Removing and installing/replacing transmission oil cooler for automatic transmission (N55)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Risk of scalding!
Only perform this repair work after engine has cooled down.

Necessary preliminary tasks:

Remove FAN COWL .

Recycling

Transmission oil emerges when fluid lines are detached from transmission oil cooler.

Catch and dispose of escaping transmission oil in a suitable container.

Observe country-specific waste disposal regulations.

Release screws (1) on left and right from cover (3).

Tightening torque 17 10 1AZ .

Release screws (2) behind sealing lip.

Tightening torque 17 10 1AZ .

Lift out cover (3).

Fig 1: Identifying Cover, Sealing Lip And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock transmission oil lines (1) and detach.

Catch and dispose of escaping transmission oil in a suitable container.

Fig 2: Identifying Transmission Oil Lines

Courtesy of BMW OF NORTH AMERICA, INC.

Remove transmission oil cooler (1), feed out towards top and remove.

Fig 3: Identifying Transmission Oil Cooler

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Assemble engine.
Check OIL LEVEL in automatic transmission. If necessary, top up automatic transmission oil.