17 11 100 Removing and installing/replacing coolant expansion tank (N55, N57 D30 U/O/T 0/1)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Follow INSTRUCTIONS FOR REPAIR WORK ON THE COOLING SYSTEM .
Only for vehicles with the Dynamic Drive:
Remove LEFT TRAILING LINK .
Remove intake port.
Release expansion tank . See 32 41 250 REMOVING AND INSTALLING/REPLACING FLUID RESERVOIR FOR HYDRAULIC STEERING or 32 41 280 REMOVING AND INSTALLING/REPLACING OIL RESERVOIR for Dynamic Drive and place to one side.

Release screw (1).

Tightening torque 17 10 3AZ .

Clamp off coolant hoses (2) with a suitable tool.

Release and disconnect coolant hoses (2).

Raise expansion tank (3)

Fig 1: Identifying Coolant Hoses, Expansion Tank And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) on coolant level switch and disconnect.

Remove expansion tank (2).

Fig 2: Identifying Expansion Tank And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Top up COOLANT .

Check cooling system for LEAK TIGHTNESS .