61 31 221 Removing and installing/replacing both multifunction steering wheel switches (M sports steering wheel)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

REMOVE AIRBAG UNIT

Release screws (1) on steering wheel.

Release screw (2) on rear side of steering wheel.

Remove design cover.

Installation note:

Make sure design cover is correctly seated.

Fig 1: Identifying Steering Wheel Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Steering wheel is shown removed for purposes of clarity.

Both multifunction steering wheel switches are connected to each other by wiring harness (2).

Release screws (1) for shift paddles.

Feed out wiring harness (2) and disconnect plug connection (3).

Installation note:

Make sure electrical wiring is correctly routed.

Fig 2: Identifying Shift Paddles Screws And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Steering wheel is shown removed for purposes of clarity.

Lift off shift paddles and release screws (1) on rear side of steering wheel.

Remove both multifunction steering wheel switches with wiring harness on front side of steering wheel.

Installation note:

Make sure electrical wiring is correctly routed.

Make sure shift paddles are correctly seated.

Make sure multifunction steering wheel switches are correctly seated.

Fig 3: Identifying Steering Wheel Screws (Rear Side)

Courtesy of BMW OF NORTH AMERICA, INC.