61 31 014 Removing and installing/replacing Start/Stop switch
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Incorrectly installed start/stop switch may cause the start/stop switch or MSA button to jam.
In the case of a fault message "Jammed start/stop switch or MSA button" check before replacing whether the start/stop switch has been correctly installed in the cover and is de-energized!
If necessary install the existing start/stop switch again and perform a functional check!
In the case of a fault message "Jammed start/stop switch or MSA button" check before replacing whether the start/stop switch has been correctly installed in the cover and is de-energized!
If necessary install the existing start/stop switch again and perform a functional check!
Necessary preliminary tasks:
- Remove decorative strip on dashboard in middle. See 51 45 385 REMOVING AND INSTALLING/REPLACING MIDDLE DECORATIVE STRIP ON DASHBOARD .
Release screws (1) and remove Start/Stop switch (2).
Installation note:
Only F10/F11/F12/F13/F18:
The tab of the start/stop switch (1) be installed below the tab (2)!