61 67 100 Removing and installing/replacing left high-pressure nozzle of headlight cleaning system

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

13 3 010

Necessary preliminary tasks:

Remove front bumper panel. See 51 11 156 REMOVING AND INSTALLING (REPLACING) FRONT BUMPER PANEL .

To prevent excess escape of washer fluid, seal off end of high pressure line with special tool. 13 3 010

Fig 1: Sealing Off End Of High Pressure Line Using Special Tool 13 3 010

G04727677

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock high pressure line (1) and detach from high-pressure nozzle (2).

Fig 2: Identifying High Pressure Line And High-Pressure Nozzle

G06895146

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock high-pressure nozzle (1) and remove in direction of arrow rearwards.

Fig 3: Removing High-Pressure Nozzle

G06895147

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Ensure guide (1) is correctly seated.

New washer jets are already preset.

Top up washer fluid.

Carry out function check.

Fig 4: Identifying Guide

G06895148

Courtesy of BMW OF NORTH AMERICA, INC.