61 35 115 Removing and installing/replacing footwell module

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE CABLE .
Detach both battery cables for negative terminal in F03.
Remove footwell side trim panel on A-pillar, left. See 51 43 070 REMOVING AND INSTALLING/REPLACING SIDE TRIM PANEL, FOOTWELL, ON A-PILLAR, LEFT .

Disconnect connector connections (1) and (3).

Release nuts (2) and remove footwell module (4).

Tightening torque 61 35 4AZ .

Fig 1: Identifying Footwell Module, Connector Connections And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/CODING .