61 35 015 Removing and installing (replacing) control unit for Car Access System
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary tasks:
- Disconnect NEGATIVE BATTERY CABLE
- Remove both battery earth leads at F03
- Remove trim panel for pedal mechanism. See 51 45 184 REMOVING AND INSTALLING (REPLACING) TRIM PANEL FOR PEDAL MECHANISM (US ONLY) or 51 45 184 REMOVING AND INSTALLING (REPLACING) TRIM PANEL FOR PEDAL MECHANISM (ECE ONLY) .
Disconnect plug connection (1).
Release screw (2).
Tightening torque 61 35 1 AZ .
Remove control unit for Car Access System (3) in direction of arrow.
Installation note:
Feed guide (1) of control unit for Car Access System (2) correctly into associated mounting.
Replacement:
Carry out PROGRAMMING/ENCODING
For vehicles with rear-seat entertainment (RSE):
Teach in RSE master key via path:
- Body
- Rear seat entertainment system
- Teach in radio remote control
- Radio remote control