61 21 010 Remove and install or replace battery
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Observe SAFETY INFORMATIONS
for handling vehicle battery.
To ensure the correct safety and convenience functions, install only the original battery (battery size and type) stored in the vehicle order. OBSERVE NOTE ON BATTERY REPLACEMENT .
Necessary preliminary tasks:
- Remove POWER DISTRIBUTION BOX
Release screws (1).
Tightening torque 61 21 5AZ .
Remove retaining bracket (2) from battery (3).
Loosen nut (1).
Tightening torque 61 21 1AZ
IMPORTANT:
Do not under any circumstances use force to pull or lever off safety battery terminal.
Pull off safety battery terminal (2) towards top, lay to one side and secure.
Remove vent line (3).
NOTE:
- Always route ventilation line (1) at a downhill gradient outwards to prevent any siphonic action.
- Fig 3 depicts both an incorrect installation and correct installation.
Release screw (1) and remove side holder (2).
Tightening torque 61 21 5AZ .
Remove battery.
Installation note:
Ensure correct fit of the battery in the battery fixture.
Extra in versions starting from 07/2013:
Release screw (1) and remove rear holder.
Tightening torque 61 21 5AZ
Remove battery.
Replacement:
- Vehicles with intelligent battery sensor (IBS)
NOTE:
If Check Control message is present:
- Delete fault memory