33 41 151 Replacing left or right wheel bearing on rear axle shaft (640i, 640i xDrive, 650i, 650xi)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not damage multi-pole impulse ring.
Necessary preliminary tasks:
- Remove DRIVE FLANGE FOR REAR AXLE SHAFT .
- Remove TOE ARM FROM WHEEL CARRIER .
NOTE:
- Check brake pads and replace if necessary!
Release screws.
Tightening torque 33 41 2AZ .
Remove wheel bearing.
Installation note:
Replace screws.
Installation note:
Keep contact surface (1) of wheel bearing and wheel carrier clean and free from oil and grease.