Installation note on spur gearing

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: This installation note must be observed without fail!

Spur gearing of bearing (1) and output shaft (2) must be installed form-fit (tooth in tooth)!
Tighten collar bolt and compression spring by hand.
Check whether spur gearing is locked tooth in tooth by reciprocally rotating wheel hub/output shaft.

Fig 1: Installing Bearing Spur Gear
Courtesy of BMW OF NORTH AMERICA, INC.
Once a form-fit has been ensured, tighten to final torque.
Tightening torque 33 41 1AZ .