33 32 153 Removing and installing/replacing front compression strut

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle
Driving without compression struts is not permitted!

Necessary preliminary tasks:

Remove TRAILING LINK TO REAR AXLE .

Release screws of underbody panelling (1).

Remove underbody panelling (1).

Fig 1: Locating Underbody Panelling Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 33 33 2AZ .

Release screw (2) and remove compression strut (3).

Tightening torque 33 33 1AZ .

IMPORTANT: Secure rear axle support by inserting screw (2).

Installation note:

Check threads for damage; if necessary, repair with HELICOIL THREAD INSERTS .

Fig 2: Identifying Compression Strut Screw

Courtesy of BMW OF NORTH AMERICA, INC.