33 32 051 Removing and installing/replacing left or right anti-roll bar link/integral link

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the integral link is detached from the swinging arm, it is necessary after installation to carry out a chassis/wheel alignment check.

Necessary preliminary work:

Remove REAR WHEEL .

Release nut (1) and remove screw.

Tightening torque 33 32 4AZ .

Release screw (2) and remove integral link (3).

Tightening torque 33 32 5AZ .

Installation note:

Replace screw and nut.

Tighten screw connections in NORMAL POSITION .

Fig 1: Identifying Integral Link, Screw And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform chassis/wheel alignment check. See ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT (WITHOUT VEHICLE LOAD) .