33 33 040 Removing and installing/replacing reinforcement plate

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle
Driving without reinforcement plate is not permitted!

Necessary preliminary tasks:

Remove the DIFFUSER .

Release screws (1).

Tightening torque 51 61 16AZ .

Installation note:

Replace screws (1).

Unfasten screws (2).

Tightening torque 33 33 5AZ .

Release screws (3).

Tightening torque 33 33 6AZ .

Fig 1: Identifying Reinforcement Plate Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace screws (3).

Remove reinforcement plate to the rear.