31 53 040 Removing and installing/replacing right output shaft bearing block (AWD)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- REMOVE right output shaft.
Release holder (1) from bearing support.
Unfasten screws (2).
Tightening torque 31 60 1AZ .
Remove bearing block (3) from oil sump.
Installation note:
Replace O-RING .
Replace SHAFT SEAL .