23 00 037 Installing exchange transmission (GS6-53BZ) N63, S63
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completion of work, check gearbox oil level
. See 00 11 229 CHANGING/TOPPING UP/CHECKING GEAR OIL IN MANUAL TRANSMISSION
or 00 11 229 CHANGING/TOPPING UP/CHECKING GEAR OIL IN MANUAL TRANSMISSION
.
Use only the approved transmission oil. Refer to OPERATING FLUIDS
Use only the approved transmission oil. Refer to OPERATING FLUIDS
Failure to comply with this instruction will result in serious damage to the transmission.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations
Necessary preliminary tasks:
- Drain transmission oil at oil drain plug.
Tightening torque 23 00 2AZ .
- Remove transmission . See 23 00 018 REMOVING AND INSTALLING TRANSMISSION (GS6-53BZ) (N63) or 23 00 018 REMOVING AND INSTALLING TRANSMISSION (GS6-53BZ) (S63 USA) .
Remove transmission support block from transmission.
Installation note:
Tightening torque 22 32 1AZ .
Slide back retaining ring (1) and drive out cylinder pin (2).
Transfer gearshift rod joint.
NOTE:
Check damping disc (6) for damage and replace if necessary.
Convert following components from previous transmission to new transmission.
- RELEASE BEARING AND RELEASE LEVER .
- Ball pin and wire spring clip
- Stud bolts for clutch slave cylinder
- PULSE GENERATOR, CRANKSHAFT/TRANSMISSION
- Transmission oil pump
- REVERSING LIGHT SWITCH
- Modify zero-gear sensor.
Tightening torque 23 14 2AZ .
- Adjust zero-gear sensor
Reassemble the vehicle.
Check oil level.
Installation note:
Observe greasing specification. Refer to OPERATING FLUIDS