13 62 593 Removing and installing/replacing pressure sensor on left plenum chamber (N63)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault memory of DME control unit
Turn off ignition
Remove coolant EXPANSION TANK
Remove FLUID RESERVOIR for hydraulic steering
Remove WATER VALVE for heater/air conditioner and lay coolant hoses to one side
Release suction line . See 32 41 315 REPLACING SUCTION LINE FOR POWER STEERING (FROM CONNECTING PIECE TO VANE PUMP) or 32 41 314 REPLACING SUCTION LINE FOR POWER STEERING (FROM FLUID RESERVOIR TO CONNECTING PIECE) for hydraulic steering and place to one side, do not remove
Secure ENGINE in installation position

Unlock plug (1) and remove.

Release screws (2) with a reversible ratchet, extension, universal joint and a magnetic Torx socket.

Tightening torque 13 62 2AZ .

Pull pressure sensor (3) out of left plenum chamber.

Installation:

Coat sealing ring with anti-friction agent.

Fig 1: Identifying pressure sensor, Screws And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

clear fault memory.