13 62 592 Removing and installing/replacing pressure sensor on right charge-air cooler (S63B44 T 0)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out the fault memory of the DME control unit.
Switch off ignition
Remove right-hand INTAKE SILENCER HOUSING

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 7AZ .

Pull pressure sensor (3) out of right intercooler.

Installation note:

Replace sealing ring on pressure sensor.

Fig 1: Identifying Pressure Sensor Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.