13 62 591 Removing and installing/replacing pressure sensor on left charge air cooler (N63 B40/44 O 0/1)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault code memory of the DME control unit.
Switch off ignition
Remove left intake port. See 13...... REMOVING INTAKE DUCT (N63) and 13...... REMOVE THE INTAKE PORT (N63 B40/B44 O 1)

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 7AZ .

Pull pressure sensor (3) out of left charge air cooler.

Installation note:

Replace sealing ring on pressure sensor.

Fig 1: Identifying Pressure Sensor, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.