13 62 531 Replacing coolant temperature sensor (S63 B44 T 0)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of scalding!
Only perform this repair work after engine has cooled down.
Only perform this repair work after engine has cooled down.
IMPORTANT:
Protect alternator against coolant.
Cover alternator with suitable apparatus (risk of damage) .
Cover alternator with suitable apparatus (risk of damage) .
Necessary preliminary tasks:
- Read out fault memory of the DDE control unit, work through test plans if necessary.
- Switch off ignition.
- Remove right INTERCOOLER .
- Release AUXILIARY WATER PUMP for exhaust turbocharger and place to one side.
Unlock connector (1) and remove.
Unfasten coolant temperature sensor (2).
Installation note:
Tightening torque 13 62 1AZ .
Delete fault memory.