13 71 150 Removing clean air pipe (N55)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove IGNITION COIL COVER

Release clamps (1).

Tightening torque 13 71 3AZ .

Unlock plug (2) on air-mass sensor and disconnect.

Disconnect clean air pipe (3) from rubber mount at top and remove.

Fig 1: Identifying Air Pipe, Connector And Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock tank ventilation line (1) and disconnect.

Release screw (2).

Tightening torque 13 71 5AZ .

Unlock plug (3) from heating element and disconnect.

Do not loosen the vent hose at cylinder head cover (4). Risk of damage to the cylinder head cover!

Release screws at clean air pipe and disconnect vent hose from clean air pipe.

Release clamp (5).

Fig 2: Identifying Tank Ventilation Line, Cylinder Head Cover, Plug And Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 13 71 7AZ .

Remove clean air pipe.

Assemble engine.