34 11 Front Brake

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

FRONT BRAKE SPECIFICATION

IMPORTANT: Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension for "MIN TH" (see table). Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm!(Not applicable to perforated brake discs and M vehicles).Applies only to M vehicles and perforated ventilated brake discs:The brake discs must be replaced once they wear to the nominal specified thickness (see table) minus 1.6 mm!.Depending on: Engine type Transmission version Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.) different brake discs can be fittedThe brake discs must always be assigned by way of the relevant vehicle identification number.
Different thicknesses on brake linings	Max. mm	0.01
Nominal size (diameter x thickness)	mm	348x36
(MIN TH) is stamped in brake disc chamber	mm	34.4
Nominal size (diameter x thickness)	mm	374x36
(MIN TH) is stamped in brake disc chamber	mm	34.4
Wear warning from residual lining thickness	mm	3.7