32 41 317 Replace intake pipe for hydraulic pump (from connecting piece to vane pump)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.

Recycling:

Catch and dispose of hydraulic fluid in a suitable collecting vessel.

Necessary preliminary tasks:

Draw off and dispose of hydraulic fluid from oil reservoir
Remove left clean air pipe.
Release the electromechanical power steering box . See 32 13 070 REMOVING AND INSTALLING ELECTRIC STEERING BOX (EPS) or 32 13 076 REPLACING ELECTRICAL STEERING BOX ACTIVE STEERING on the front axle support and pull forwards slightly

Unfasten hose clamp (1).

Release screw (2).

Tightening torque 32 41 8AZ .

Installation note:

Replace hose clamp.

Fig 1: Identifying Hose Clamp And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release hose clamp (1) and detach intake pipe from vane pump.

Installation note:

Replace hose clamp.

Make sure hydraulic lines are laid without tension and with sufficient distance to adjoining components.

Align intake pipe by way of marking (2) to marking on the vane pump connection.

Fig 2: Identifying Hose Clamp And Intake Pipe Marking

Courtesy of BMW OF NORTH AMERICA, INC.

Remove suction line (1) in direction of arrow from holder (2).

Remove intake pipe in upward direction.

Fig 3: Removing Suction Line

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Carry out INITIAL DYNAMIC DRIVE OPERATION
Check pipe connections for leaks