32 41 316 Replace intake pipe for hydraulic pump (from oil reservoir to connecting piece)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.

Recycling:

Catch and dispose of hydraulic fluid in a suitable expansion tank.

Necessary preliminary tasks:

Draw off and dispose of hydraulic fluid from oil reservoir
Remove OIL RESERVOIR from body
Remove RAW-AIR SUPPLY on left

Unfasten hose clamp (1).

Disconnect intake pipe (2) from oil reservoir.

Installation note:

Marks on fluid reservoir and intake pipe must match up.

Replace hose clamp.

Fig 1: Identifying Hose Clamp And Intake Pipe

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten hose clamp (1).

Remove intake pipe (2).

Installation note:

Replace hose clamp.

Make sure intake pipe is laid without tension and with sufficient distance to adjoining components.

Fig 2: Identifying Intake Pipe And Hose Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Carry out INITIAL DYNAMIC DRIVE OPERATION
Check line connections for leaks