32 41 316 Intake pipe to hydraulic pump (from oil reservoir to connecting piece) (N63T)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.
Close off line connections with seal plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable expansion tank.
Necessary preliminary work:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Remove left INTAKE PORT
- Remove ENGINE CONTROL UNIT from oil reservoir and place to the side
(Do not pull off the coolant hose on the control unit!)
Loosen hose clamps (1).
Pull off intake pipe (2) on the oil reservoir and on the connecting piece.
Installation note:
Make sure intake pipe is laid without tension and with sufficient distance to adjoining components.
Marks on the oil reservoir and intake pipe resp. intake pipe and adapter must match.
Replace hose clamp.
Tightening torque 32 41 3AZ .
After installation:
- Fill and bleed hydraulic system . See 32 13 006 BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) or 32 13 006 BLEEDING POWER STEERING UNIT
- Check line connections for leaks