27 21 010 Replacing Radial Shaft Seal For Drive Flange (ATC 350)

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2016 BMW 550i xDrive, 2016 BMW 535i xDrive, 2016 BMW 535d xDrive, 2016 BMW 528i xDrive, and 2015 BMW 550i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

23 0 490
27 1 430

IMPORTANT: After completing work, check TRANSMISSION OIL LEVEL and top up if necessary.
Use only the approved transmission oil .

Necessary preliminary tasks:

Remove TRANSFER BOX .

Drive a hole into radial shaft seal (1) using a center punch (2).

IMPORTANT: Do not use a drill as drillings may result in transmission malfunction.

Fig 1: Drilling Hole Into Radial Shaft Seal

G04745123

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 23 0 490 into radial shaft seal.

Drive out radial shaft seal (1) with impact weight (2).

Fig 2: Removing Radial Shaft Seal

G04745124

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Coat sealing lips of new radial shaft seal with clean transmission oil.

Drive in radial shaft seal with special tool 27 1 430.

Fig 3: Installing Radial Shaft Seal

G04745125

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.

Check TRANSMISSION OIL LEVEL .

Check transmission for leaks.