67 61 007 Removing and installing/replacing drive with gearbox (rear) for actuating slide/tilt sunroof (rear)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Lower HEADLINING .

Disconnect plug connection (1) and if necessary expose cable.

Release screws (2) and remove drive (3).

Tightening torque 54 13 1AZ .

Fig 1: Identifying Drive Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Insert gear (1) of electric motor with gearbox for operation of slide/tilt sunroof (2) exactly in gearing (3).

Fig 2: Identifying Gear Wheel, Actuating Slide/Tilt Sunroof And Gear Teeth

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Initialize SLIDE/TILT SUNROOF .