22 32 070 Removing and installing/replacing the transmission bearing support (N55, N57) all-wheel drive vehicle
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove rear UNDERBODY PROTECTION and retaining plate on left.
- Release the FRONT PROPELLER SHAFT from the transfer box
Release screws (1) and nuts (2).
Remove transmission bearing support on left transmission side.
Tightening torque 22 32 9/10AZ .