61 31 020 Removing and installing ignition switch

WARNING: This page is about a different car, the 2003 BMW X5 and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Remove top section of steering column casing, refer to STEERING COLUMN TRIM (UPPER SECTION) .

Remove lower section of steering column trim, refer to STEERING COLUMN TRIM (LOWER SECTION) .

Unlock plug connection (1) and disconnect.

Fig 1: Disconnecting Ignition Switch Harness Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1).

Move fixture (2) for wiring harness slightly.

Fig 2: Loosening Wiring Harness Fixture Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove sealing varnish and release headless setscrews (1).

Fig 3: Removing Ignition Switch Headless Setscrews

Courtesy of BMW OF NORTH AMERICA, INC.

Detach ignition switch (2) in direction of arrow.

Installation:

Secure headless setscrews with sealing varnish.