61 62 030 Replacing wiper arm for rear window wiper: Procedure
WARNING: This page is about a different car, the 2003 BMW X5 and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Lever out cap (1) at side and remove.
Installation:
Catches (1) of cap (2) must not be damaged.
Unscrew nut (1).
Installation:
Observe tightening torque, refer to 61 62 2AZ in GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES - X5 .
Detach wiper arm (1) with special tool 616 060 and remove.
Installation:
Wiper motor must be in end position.
Adjust distance (1) between wiper arm and rear window edge.
(1) 32.5+/-2mm