54 10 175 Removing and installing rear glass slide/tilt sunroof cover

WARNING: This page is about a different car, the 2003 BMW X5 and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following steps can be carried out inside the vehicle with the glass roof panel fully closed.

Open floating roofliner fully.

NOTE: Make sure that grease at the ends of the rail do not come into contact with the roofliner.

This Step is not necessary for replacement:

Before removing the Torx screws, make a mark around the washers in order to ensure correct alignment during installation.

Remove and dispose of the Torx screws (1) securing the glass panel to the mechanism.

Installation:

Insert new Torx screws and align washers to markings.

Fig 1: Installing Glass Panel To Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque, refer to 54 12 2AZ in SLIDE/TILT ROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES - X5

IMPORTANT: A second person is required to help in removing and installing the glass slide/tilt sunroof lid!

Lift out glass slide/tilt sunroof cover (1).

Fig 2: Lifting Out Rear Slide/Tilt Sunroof Glass

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Tape off complete edge area at roof aperture with fabric adhesive tape (risk of damage).

Install glass slide/tilt sunroof cover carefully (twist in) as seal can be damaged during installation.

Check glass slide/tilt sunroof cover for correct alignment and adjust if necessary. Refer to 54 13 003 ADJUSTING GLASS SLIDE/TILT SUNROOF LID .