LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 366 (Slide/Tilt Roof - Repair Instructions - X5 (4.6L)) >> Mechanical Sun Roof Components >> 54 12 003 Adjusting glass sliding/tilting sunroof lid >> Procedure

54 12 003 Adjusting glass sliding/tilting sunroof lid: Procedure

WARNING: This page is about a different car, the 2003 BMW X5 and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Initialize slide/tilt sunroof,

refer to 54 0 ... NOTES ON PANORAMA GLASS ROOF (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE)  .

Ideal adjustment:

Gaps (A) between sunroof and front and back of roof of equal size.

Fig 1: Identifying Gap "A" Between Sunroof And Roof
G03256333Courtesy of BMW OF NORTH AMERICA, INC.

Slide special tool 00 9 340 between seal and lid. Checks (sliding out and in) must show special tool to display uniform resistance.

SUNROOF INSTALLED HEIGHT SPECIFICATIONS

Height front flush or up to 1 mm lower
  rear flush up to 1 mm higher

Slowly slide roof-lining frame towards rear up to dimension (A).

Fig 2: Moving Roof-Lining Frame To Dimension "A"
G03256334Courtesy of BMW OF NORTH AMERICA, INC.
ROOF-LINING FRAME DIMENSION "A"

(A) E38 80 mm
  E39, E53 70 mm

Press switch in direction of "raise position" (fan setting) until lid is raised to max. setting.

Fig 3: Raise Roof To Maximum Position
G03256335Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Grasp the bellows by hand only at the first fold (1) (risk of damage).

Detach bellows starting from center (A) towards front and rear (B) from glass slide/tilt sunroof lid (2).

Fig 4: Disconnecting Bellows From Glass Slide/Tilt Sunroof Lid
G03256336Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1) and (2) with special tool 00 2 130.

Fig 5: Loosening Glass Sunroof Lid Screws
G03256337Courtesy of BMW OF NORTH AMERICA, INC.
NOTE: Pull bellows down until screw (2) is accessible. Loosen screws only to the extent that the glass sunroof lid can only just be adjusted.
Close glass sunroof lid (zero position).

Press glass slide/tilt sunroof lid forwards, press downwards at front and rear until ideal position is achieved and tighten down screws.

Installation: 

Tightening torque, refer to 54 12 2AZ in SLIDE/TILT ROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES - X5

Check function.

Slowly pull roof-lining frame completely forwards.

Fig 6: Closing Roof-Lining Frame
G03256338Courtesy of BMW OF NORTH AMERICA, INC.