27 21 010 Renewing radial shaft seal for drive flange (ATC 35L)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2016 BMW 550i GT xDrive, 2016 BMW 535i GT xDrive, and 2015 BMW 550i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

23 0 490
27 1 430

IMPORTANT: After completing repair work, check TRANSMISSION OIL LEVEL and top up if necessary.
Use only the approved transmission oil. Refer to 1.0 TRANSFER CASE OPERATING FLUIDS .

Necessary preliminary work

Remove transfer box . See 27 10 010 REMOVING AND INSTALLING TRANSFER BOX (ATC 350) or 27 10 010 REMOVING AND INSTALLING TRANSFER BOX (ATC 35L) .

Drive a hole into radial shaft seal (1) using a center punch (2).

IMPORTANT: Do not use a drill as drillings may result in transmission malfunction.

Fig 1: Driving Hole Into Radial Shaft Seal Using Center Punch

G04745123

Courtesy of BMW OF NORTH AMERICA, INC.

Screw special tool 23 0 490 into radial shaft seal.

Drive out radial shaft seal (1) with impact weight (2).

Fig 2: Driving Out Radial Shaft Seal With Impact Weight

G04745124

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Coat sealing lips of new radial shaft seal with clean transmission oil.

Drive in radial shaft seal with special tool 27 1 430.

Fig 3: Installing Radial Shaft Seal Using Special Tool (27 1 430)

G04745125

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.

Check TRANSMISSION OIL LEVEL .

Check transmission for leaks.