51 43 201 Removing and installing/replacing panel for roof pillar at front (A-pillar), left or right

WARNING: This page is about a different car, the 2003 BMW X5 and 2002 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use sharp-edged tools to remove trim (risk of damage to head air bag).

Detach mucket on outside in area of panel (1).

Remove plate (2).

Unscrew bolt (3).

Fig 1: Removing Panel For Roof Pillar At Front (A-Pillar) Fasteners

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque, refer to 51 43 2AZ in BODY EQUIPMENT - TIGHTENING TORQUES .

Unclip panel (1) at top and detach towards top.

Fig 2: Removing Panel For Roof Pillar At Front (A-Pillar)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1).

Align plastic lug (2) to retainer in A-pillar.

Fig 3: Replace Faulty Roof Pillar Panel Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Viewing direction through windscreen:

Insert panel for roof pillar (1) into groove (2) of trim panel for instrument panel.

Fig 4: Installing Panel For Roof Pillar At Front (A-Pillar)

Courtesy of BMW OF NORTH AMERICA, INC.