51 22 090 Removing and installing/replacing door lock on left or right rear door

Raise the door window.

Remove sound insulation on rear door, refer to 51 48 ... REMOVING AND INSTALLING/REPLACING SOUND INSULATION IN REAR DOOR, LEFT OR RIGHT .

Disconnect plug connection (1) on door lock (2).

Fig 1: Disconnecting Plug Connection On Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip ball head (1).

Detach Bowden cable (2) from support (2) on door lock.

Fig 2: Unclipping Ball Head & Detach Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 3: Removing Rear Door Lock With Linkage

Courtesy of BMW OF NORTH AMERICA, INC.

Remove door lock (2) with linkage (3).

Installation: 

Insert linkage for locking knob through opening in inner door plate.

Do not bend linkage (3).

Replace screws (1).

Tightening torque, refer to 51 22 1AZ in BODY EQUIPMENT - TIGHTENING TORQUES .

Installation: 

Carry out function check only with door open.

• Close rotary latch lock (1) with a screwdriver.
• Lock car with car key.
• Unlock car with car key.
• Open rotary latch lock (1) with outside door handle.
• If rotary latch lock opens, then O.K.
• If rotary latch lock fails to open, a new lock actuator must be fitted.

Fig 4: Function Check Of Rear Door

Courtesy of BMW OF NORTH AMERICA, INC.

Only replacement: 

Lift out lock (1) and detach Bowden cable (2) from fixture (3).

Remove Bowden cable nipple (4) from lever (5).

Fig 5: Detach Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Only replacement:

Unclip linkage for locking knob (2) from support (1) and feed out of guide (3).

Fig 6: Removing Linkage For Locking Knob

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Following parts must not be damaged or missing:

1. Spring
2. Support for Bowden cable of lock plate
3. Mount for linkage of locking knob
4. Lever for child safety catch

Fig 7: Checking Parts For Damaged Or Missing Parts

Courtesy of BMW OF NORTH AMERICA, INC.