22 32 055 Removing and installing/replacing transmission bearing block (N55, N57) all-wheel drive vehicle
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 51 3 310
Necessary preliminary tasks
- Remove TRANSMISSION SUPPORT BRACKET
- Release TRANSMISSION CROSS-MEMBER from body.
- Slightly lower the transmission.
Release screws (1) with special tool 51 3 310.
Tightening torque 22 32 7AZ .
Remove transmission mounting bracket (2) on left transmission side.