26 12 011 Replacing grooved ball bearing in propeller shaft center bearing

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

23 1 160
33 3 202
33 3 203

Necessary preliminary tasks:

Replace PROPELLER SHAFT CENTER BEARING

Press grooved ball bearing using special tool 23 1 160 out of center mount (1).

NOTE: Illustration shows E46.

Fig 1: Pressing Grooved Ball Bearing Out Of Center Mount Using Special Tool 23 1 160

Courtesy of BMW OF NORTH AMERICA, INC.

Coat rubber-coated bearing seat of center mount (2) with Circolight.

Use special tools 33 3 202/33 3 203 to press grooved ball bearing (1) into center mount (2).

NOTE: Illustration shows E46.

Fig 2: Pressing Grooved Ball Bearing Into Center Mount

Courtesy of BMW OF NORTH AMERICA, INC.