24 13 017 Replacing output flange radial shaft seal (GA8HP70Z) AWD
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
After completion of repair work, check = transmission oil level. Refer to CHECKING TRANSMISSION FLUID LEVEL
.
Use only the approved transmission oil. Refer to APPROVED AUTOMATIC TRANSMISSION FLUIDS FOR INITIAL FILLINGS AND CORRECTING FLUID LEVELS ,
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Use only the approved transmission oil. Refer to APPROVED AUTOMATIC TRANSMISSION FLUIDS FOR INITIAL FILLINGS AND CORRECTING FLUID LEVELS ,
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks
- Remove transfer box . See 27 10 010 REMOVING AND INSTALLING TRANSFER BOX (ATC 350) or 27 10 010 REMOVING AND INSTALLING TRANSFER BOX (ATC 35L) .
Drive a hole into radial shaft seal (1) using a center punch.
IMPORTANT:
Do not use a drill as drillings may result in transmission malfunction.
Thread special tool 23 0 490 into radial shaft seal (1).
Drive out radial shaft seal (1) with impact weight (2).
Installation note:
Coat sealing lips of new radial shaft seal with clean transmission oil.
Radial shaft seal firmly home with special tool 23 3 220 .