17 51 001 Removing and installing/replacing right charge air cooler (N63)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of scalding!
Only perform this repair work after engine has cooled down!

Necessary preliminary tasks

Remove ACOUSTIC COVER .
Remove front UNDERBODY PROTECTION .
Remove FAN COWL .
FOLLOW instructions for repair work on the cooling system.

Release clamp (1).

Tightening torque 13 71 8AZ .

Release clamp (2).

Replace clamp (2).

Remove right charge-air duct (3).

Check the gasket on the exhaust turbocharger. replacing if necessary.

Fig 1: Identifying Right Charge-Air Duct And Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: When loosening the coolant hoses from the charge air cooler, make sure that the connector remains connected to the throttle body. Coolant may not penetrate the plug connection at the throttle body.

Disconnect coolant hoses from charge air cooler using PINCH-OFF TOOLS (to prevent coolant from escaping).

Catch and dispose of escaping coolant.

Release and disconnect coolant hoses (1).

Detach coolant hose (2) from charge air cooler.

Fig 2: Identifying Coolant Hoses

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screw (2).

Tightening torque 13 71 6AZ .

Installation note:

Screw (2) is longer than screws (3)

Release screws (3).

Tightening torque 13 71 6AZ .

Release clamp (4) on throttle valve unit.

Tightening torque 13 71 7AZ .

Lift out charge air cooler.

Replace faulty hose clamps.

Fig 3: Identifying Clamp, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After having completed repair work, coolant level for charge air cooler and top up if necessary.