65 50... Removing and installing/replacing trim for rear cabin monitor base in middle

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

IMPORTANT: Trims may only be replaced in pairs so as to avoid differences in color.

Move rear cabin monitor (1) into position illustrated.

Unclamp and remove trims (2) with special tool 00 9 317 .

Fig 1: Removing Trims With Special Tool 00 9 317

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove trim (2) in downward direction.

Fig 2: Identifying Screws And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining tabs (1) must not be damaged

Fig 3: Identifying Tabs

Courtesy of BMW OF NORTH AMERICA, INC.