65 50 057 Removing and installing/replacing Central Information Display (CID)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

Necessary preliminary tasks:

Remove CENTRE FRESH-AIR GRILLE

Release screws (1) and feed out CID (2) towards bottom.

Tightening torque 65 50 1AZ .

Fig 1: Identifying CID And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1) and unclip cable from holders (2).

Remove CID (3).

Installation:

Holders (2) must not be damaged!

Make sure cable is correctly routed through holders (2).

Fig 2: Identifying Plug Connections, Holders And CID

Courtesy of BMW OF NORTH AMERICA, INC.