65 83 020 Removing and installing (replacing) Car Information Computer (CIC)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Risk of damage!

A hard disk is installed in the Car Information Computer (CIC).

Carry out mechanical work on the CIC and adjacent components with care.

Avoid subjecting the CIC to vibration/shocks.

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

NOTE: Comply with notes and instructions on HANDLING OPTICAL FIBRES .

Necessary preliminary tasks:

Only E72: Disconnect BOTH NEGATIVE BATTERY CABLES
Disconnect battery earth lead
Remove MIDDLE TRIM FOR INSTRUMENT PANEL

IMPORTANT: When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Release screws (1).

Tightening torque 65 11 6AZ .

Feed out car infotainment computer (2) towards front.

Disconnect plug connections and remove car infotainment computer (2).

Fig 1: Identifying Car Infotainment Computer And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (2)/(3) and disconnect.

Remove CIC (1).

Fig 2: Identifying Plug Connections And CIC

Courtesy of BMW OF NORTH AMERICA, INC.

Only for US models with satellite tuner:

When replacing the CIC unit, additional work is required!

Follow instructions in REPLACE SATELLITE TUNER FROM 09/2009 .

Replacement:

Carry out PROGRAMMING/CODING .