63 99 145 Replacing bulb for left (or right) side lights (xenon headlight)
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Version with xenon headlights:
Danger to life due to high voltage! Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by qualified personnel.
Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .
Danger to life due to high voltage! Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by qualified personnel.
Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .
Turn protective cap (1) in direction of arrow and remove from headlight.
Installation note:
Protective cap (1) must be correctly engaged.
Check seal.
Replace protective cap (1) if necessary.
Comply with INSTRUCTIONS FOR REPLACING THE PROTECTIVE CAP .
Turn bulb for side light (2) in direction of arrow and remove from headlight (3).
Disconnect plug connection (1) and remove side light bulb (2).
Installation note:
Make sure bulb for side light (2) is correctly seated and engaged on headlight (3).
Note BULB TYPE .