LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3495 (Lights - Repair (ACTIVEHYBRID)) >> Headlights >> 63 12 870 Replacing ignition unit for left xenon headlight (with xenon bulb)

63 12 870 Replacing ignition unit for left xenon headlight (with xenon bulb)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Version with xenon headlights:
Danger to life due to high voltage! Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by qualified personnel.
Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .
IMPORTANT: Ignition unit and xenon bulb are viewed as a single component and must not be separated.

Turn cover (1) in direction of arrow and remove from headlight (2).

Installation note: 

Make sure seal is correctly fitted on cover (1).

Fit cover (1) on headlight (2) so that marking (3) is at top.

Make sure cover (1) is correctly engaged on headlight (2).

Observe NOTES FOR REPLACING THE PROTECTIVE CAP .

Fig 1: Identifying Cover, Headlight And Marking At Top
G06213618Courtesy of BMW OF NORTH AMERICA, INC.

Press in retaining bracket (1) for releasing retaining lug (2) in direction of arrow.

Disconnect plug (3) in downward direction from ignition unit for xenon headlight (4).

Turn ignition unit for xenon headlight (4) in direction of arrow and remove from headlight (5).

Fig 2: Identifying Retaining Lug, Retaining Bracket, Plug And Xenon Headlight
G06213619Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure ignition unit for xenon headlight (4) is correctly seated and engaged on headlight (5).

Unlock catch (1), expand bulb holder (2) in direction of arrow (A) on one side and remove in direction of arrow (B) from ignition unit for xenon headlight (3).

Installation note: 

Make sure bulb holder (2) is correctly seated on ignition unit for xenon headlight (3).

Guides (4) of bulb holder (2) must be positioned in associated recesses of ignition unit for xenon headlight (3).

Fig 3: Expanding Bulb Holder In Direction Of Arrow On One Side
G06213620Courtesy of BMW OF NORTH AMERICA, INC.