27 10 710 Replacing classification resistor for servomotor (ATC 700)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Delete previous resistance values when replacing the resistor.
Using BMW diagnosis system, work through test program in accordance with instructions.

Disconnect connector (1).

Release screw (2) and remove resistor.

Tightening torque 27 00 14AZ .

Fig 1: Identifying Resistor Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.