22 32 001 Replacing rubber mount for transmission mounting (ATC 450)

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

22 1 051
22 1 052
33 4 465
33 4 466
22 1 102
22 1 053

Necessary preliminary tasks:

Remove CROSS MEMBER for transmission mounting

Attach special tool 22 1 051 with screw (1) on the housing.

Pull out rubber mount with special tools 22 1 052/33 4 465 and 33 4 466 .

Fig 1: Pulling Out Rubber Mount With Special Tools (22 1 052), (33 4 465) And (33 4 466)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note

Observe installation position of rubber mount.

Arrow on rubber mount must point to arrow on housing.

Coat housing bore and rubber mount with Circolight, refer to BMW Parts Service.

Fig 2: Identifying Rubber Mount Installation Position

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool22 1 102 with bolt into recesses of rubber mount.

Fig 3: Inserting Special Tool (22 1 102) With Bolt Into Recesses Of Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount with special tools 22 1 102/22 1 053/33 4 465 and 33 4 466 .

Fig 4: Installing Rubber Mount With Special Tools (22 1 102),(22 1 053), (33 4 465) And (33 4 466)

Courtesy of BMW OF NORTH AMERICA, INC.