65 77 604 Replacing sensor mat (OC3 mat) for passenger seat occupancy detector
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Note AIRBAG SAFETY INSTRUCTIONS
!
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
WARNING:
US/CDN front passenger seat (with OC3 mat) only:
A defective OC3 mat can only be replaced together with the padding and the seat cover.
New OC3 mat is supplied with padding, seat cover and if necessary seat heating.
After fitting, the OC3 mat must be enabled with the diagnosis system.
Individual parts not available.
A defective OC3 mat can only be replaced together with the padding and the seat cover.
New OC3 mat is supplied with padding, seat cover and if necessary seat heating.
After fitting, the OC3 mat must be enabled with the diagnosis system.
Individual parts not available.
Operation for replacing the OC3 mat in conjunction with padding and seat cover is described in:
- Remove padding for passenger seat. See COMFORT SEAT , SPORTS, ELECTRIC SEAT , or NORMAL/SEMI-ELECTRIC SEAT
Enable seat occupancy detection (OC3 mat):
- Connect BMW PROGRAMMING SYSTEM
- Encode airbag control unit
- Clear fault memory if necessary